Skip to main content
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [List Home]
Re: [sumo-user] RouteSampler.py demand generation problems
Thanks Barry. I tried to remove some routes that created traffic jams in the network due to U-turn, but it only reduces some traffic jams. It doesn't solve the jam in other parts of the network. I would like to know if there is any other way to generate and check the implausible routes. Is there a way to use implausibleRoute.py with routeSampler to improve the traffic flow? 


Thanks, 
Anil 

On Mon, Jul 6, 2020 at 4:35 AM Evans, Barry <B.Evans@xxxxxxxxxxxx> wrote:
Hi Anil,

I haven't looked over the data but I had a similar problem when I was using routeSampler.py. One of causes I found for sever jams was to do with some vehicle routes either starting with or ending with a U-turn manoeuvre.

What I did was run the model in the GUI and visually look for where these jams are occurring and then click on the car that I believe to be causing the jam to see if it is attempting a U-turn either at the start of its journey or the end. If it is I'd then go into the rou.xml file in a text editor like notepad++ and look at the id of the vehicle causing the jam and trim either the beginning or the end of its route accordingly to remove the U-turn manoeuvre.

If this is the issue, removing these U-turns will help reduce jams.  I hope this helps but if not maybe someone else who is more familiar with routeSampler.py could help.

All the best,

Barry


-----Original Message-----
From: sumo-user-bounces@xxxxxxxxxxx [mailto:sumo-user-bounces@xxxxxxxxxxx] On Behalf Of anilbaral
Sent: 06 July 2020 19:23
To: sumo-user@xxxxxxxxxxx
Subject: [sumo-user] RouteSampler.py demand generation problems

CAUTION: This email originated from outside of the organisation. Do not click links or open attachments unless you recognise the sender and know the content is safe.


Hi all,
I have use routeSampler.py to generate demand with edge count data. The edge data was generated from the flow file and contains the hourly count on the edges with detectors.  I was successfully able to generate the vehicle using routeSampler, and the mismatch was almost negligible. However, when I run the simulation, I find a lot of jam during *peak hours*.  I have used the actuated traffic light and most probably traffic light is not the cause of traffic jams.  I am not sure how to deal with this problem. I think it is due to the routes that are being generated by routeSampler.py.  Please suggest how can I deal with these issues and what can be the probable causes?

Attached is the file: FILES_Sumo.rar
<https://eur03.safelinks.protection.outlook.com/?url="">>

Thanks
Anil




--
Sent from: https://eur03.safelinks.protection.outlook.com/?url="">
_______________________________________________
sumo-user mailing list
sumo-user@xxxxxxxxxxx
To unsubscribe from this list, visit https://eur03.safelinks.protection.outlook.com/?url="">
_______________________________________________
sumo-user mailing list
sumo-user@xxxxxxxxxxx
To unsubscribe from this list, visit https://www.eclipse.org/mailman/listinfo/sumo-user

Back to the top