On 20/10/2014 11:50 AM, Woodard, David wrote:
1. Kura hasn't been tested against NOOBS, only Raspian. Let me check on this and get back to you.
Sorry. I am using the latest Raspian. NOOBS is just the installer.
2. Can you send details on your WiFi module? Kura depends on tools that leverage the nl80211 interface (ex: iw), which not all chipsets support. A quick check would be to issue the command: iw dev list .
I am not even getting that far. Just changing the /etc/network/interfaces file to switch the wlan0 settings from static ip to DHCP seems to brick my Raspberry Pi.
I currently don't have iw installed (which could be part of the problem), but here is what iwconfig tells me:
iwconfig wlan0
wlan0 unassociated Nickname:"<WIFI@REALTEK>"
Mode:Managed Frequency=2.412 GHz Access Point: Not-Associated
Sensitivity:0/0
Retry:off RTS thr:off Fragment thr:off
Power Management:off
Link Quality:0 Signal level:0 Noise level:0
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
So based on
this article[1], it looks like I need to install iw and a number of other utilities to run on wifi?
[1]
http://www.pi-point.co.uk/documentation/
Any documentation on this setup that you can point me to?