On Wednesday, May 22, 2013 13:42:09 Di Sheng <disheng222@xxxxxxxxx> wrote:
> Hi,
> Through the built-in help of the latest version eclipse, I found this
> sentence:
>
> Previous releases of PTP required setting up a Resource Manager for each
> job scheduler/runtime environment before a job could be launched. In PTP
> 6.0 this is not handled separately, and instead a *Target System
> Configuration* is specified on the Run Configuration page. Further
> interaction to set up the parallel job is highly dependent on which TSC is
> selected.
>
> So, I guess I should not configure resource manager under the new version
> of eclipse.
>
> Thanks
> Sheng
Correct !
I was talking about Run Configurations -> Resources -> Target System Configuration, which replaced the Resource Manager GUI in previous versions. Here you still need to choose among the following
* MPICH2 generic interactive
* OpenMPI generic interactive
* Remote generic interactive
My choices are the latter two, for reasons outlined earlier.
As you seem to have followed some dead end paths and clicked something in some menus, I am not sure whether you may be hit by side effects from your previous actions (or settings from your previous menu clicks). How about a clean start, scratching the workspace, .project, .cproject, .settings in your source directory and then re-import the sources in a new workspace ?
--
Mit freundlichen Grüßen / Kind regards
Dr. Christoph Pospiech
High Performance & Parallel Computing
Phone: +49-351 86269826
Mobile: +49-171-765 5871
E-Mail: christoph.pospiech@xxxxxxxxxx
-------------------------------------------------------------------------------------------------------------------------------------------
IBM Deutschland GmbH / Vorsitzender des Aufsichtsrats: Martin Jetter
Geschäftsführung: Martina Koederitz (Vorsitzende), Reinhard Reschke, Dieter Scholz, Gregor Pillen, Joachim Heel, Christian Noll
Sitz der Gesellschaft: Ehningen / Registergericht: Amtsgericht Stuttgart, HRB 14562 / WEEE-Reg.-Nr. DE 99369940
|