Re: [sumo-user] Question about junctions

[Mirko Barthauer <m.barthauer@xxxxxxxxxxx>]

Dear Yanglan,

 

AFAIk this is not possible. The selection form in netedit works with the object attributes you can access as well in the inspect mode, but no derived values like the number of ingoing and outgoing edges.

 

Best regards

Mirko

 

 

 

 

-----Original-Nachricht-----

Betreff: [sumo-user] Question about junctions

Datum: 2023-12-25T09:00:56+0100

Von: "Yanglan Wang via sumo-user" <sumo-user@xxxxxxxxxxx>

An: "Sumo project User discussions" <sumo-user@xxxxxxxxxxx>

 

 

 

Dear Sumo Team,

 

I know how to replace a single junction into a geometry point by using the method shown in the figure. Is there any method that can select all junctions that are not intersected with other lanes and then change them into geometry points? 

 

Thanks a lot!

 

Best, 

Yanglan