Thanks for the response Harald.
The arguments I used for the Python script look
something like this:
python
compute-pass-per-vehicle-with-sumo_3b.py -f 3600
-l 60000 -v 0 1 2 3 4 5 6 7 -g True -- -c
test.sumocfg
-f 3600
-l 60000
-v 0 1 2 3 4 5 6 7
-g True
--
-c test.sumocfg
I ran the scenario in the sumo
gui rather than in sumo to see how some of the
vehicles in the simulation were behaving based on
the commands in the Python script. That may be why
the vehicles are teleporting when you run it in
plain sumo as opposed to giving you a fatal error
(as seen when you run in sumo gui).
Sent from Mail for Windows
Hi Ifezue,
please provide also the arguments for the python
script or add a simple run.bat file, which just
calls compute-pass-per-vehicle-with-sumo_3b.py
with the correct parameters
Running
a program with traci is always slower than
without.
If I
run your scenario with plain sumo, I see that
buses 3 and 4 are teleported:
Warning: Teleporting vehicle
'3'; waited too long (wrong
lane), lane='374986789.109.16_1', time=5435.00.
Warning: Vehicle '3'
ends teleporting on edge '374986789.138', time
5435.00.
Warning: Teleporting vehicle
'4'; waited too long (wrong
lane), lane='374986789.109.16_1', time=34896.00.
Warning: Vehicle '4'
ends teleporting on edge '374986789.138', time
34896.00.
Warning: Teleporting vehicle
'4'; waited too long (wrong
lane), lane='374986789.109.16_1', time=53365.00.
Warning: Vehicle '4'
ends teleporting on edge '374986789.138', time
53365.00.
If
you have still trouble or fatal errors, please
provide the scenario with the calling
parameters, so I can reproduce your error.
Harald
Am 23.10.21 um 00:57 schrieb
vincentobiako:
Hello Everyone
I have a simulation with
buses that are running on multiple routes and
when each bus reaches a certain fuel capacity
and a bus capacity equal to 0, they are required
to begin the process of refueling by going to a
charging station. I have been able to get the
vehicles to move to their recharging station
when two conditions are met but once they get to
the station and begin recharging they all seem
to get stuck on the same lane or charging
location and the SUMO gui crashes and I get a
Fatal Error message in my command prompt.
I have tried shortening the
charging delay and actual charging duration that
each bus spends in the process of refueling or
recharging to see if that will prevent the Fatal
Error from occurring and allow the buses to move
on to their next bus stop, but I keep getting a
Fatal Error message. Another thing I noticed
when I was doing this is that the simulation in
the GUI seemed to run significantly slower than
normal for some reason and I am not sure why.
Does anyone know why I am
getting a Fatal Error message and how I can get
the buses to refuel and then move on with rest
of their bus routes after they are done
refueling/recharging? Also, why is my simulation
running slow when I execute my code in TraCI?
I have attached my testing
files for reference.
Thank you
Ifezue
Sent from Mail for Windows
_______________________________________________
sumo-user mailing list
sumo-user@xxxxxxxxxxx
To unsubscribe from this list, visit https://www.eclipse.org/mailman/listinfo/sumo-user