[
Date Prev][
Date Next][
Thread Prev][
Thread Next][
Date Index][
Thread Index]
[
List Home]
|
[sumo-user] Vehicles are not refueling (was Re: Fatal Error during vehicle Refueling using TraCI)
|
Hi Ifezue,
you should set the efficiency in your charging station to a
reasonable value (e.g. 0.95)
Regards Harald
Am 23.10.21 um 00:57 schrieb
vincentobiako:
Hello Everyone
I have a simulation with buses that are
running on multiple routes and when each bus reaches a certain
fuel capacity and a bus capacity equal to 0, they are required
to begin the process of refueling by going to a charging
station. I have been able to get the vehicles to move to their
recharging station when two conditions are met but once they
get to the station and begin recharging they all seem to get
stuck on the same lane or charging location and the SUMO gui
crashes and I get a Fatal Error message in my command prompt.
I have tried shortening the charging delay
and actual charging duration that each bus spends in the
process of refueling or recharging to see if that will prevent
the Fatal Error from occurring and allow the buses to move on
to their next bus stop, but I keep getting a Fatal Error
message. Another thing I noticed when I was doing this is that
the simulation in the GUI seemed to run significantly slower
than normal for some reason and I am not sure why.
Does anyone know why I am getting a Fatal
Error message and how I can get the buses to refuel and then
move on with rest of their bus routes after they are done
refueling/recharging? Also, why is my simulation running slow
when I execute my code in TraCI?
I have attached my testing files for
reference.
Thank you
Ifezue
Sent from Mail for Windows
_______________________________________________
sumo-user mailing list
sumo-user@xxxxxxxxxxx
To unsubscribe from this list, visit https://www.eclipse.org/mailman/listinfo/sumo-user
