| [sumo-user] Intermodal routing with looping shuttle |
|
Moderator: Please note that I sent this email on September 30th. The moderator who reviewed it rejected it because I am not a subscriber to this group. I followed up with a separate email to
sumo-user-owner@xxxxxxxxxxx and attached the initial email I received confirming my subscription to this mailing list. I also sent an email about rerouters a few weeks ago and it was approved and ultimately answered.
Furthermore, I went to the eclipse.org site for this mailing list and it indicates that I am subscribed. Please approve this email at your earliest convenience. Hello, I am trying to simulate the effect of having a looping shuttle route on intermodal pedestrian trips in a neighborhood. I previously wrote to the mailing list about how to use rerouters to generate one vehicle that follows the same loop.
The response was very helpful and I got my simulation working, thank you. Now I am trying to add in the pedestrians and observe that the presence of the shuttle loop has no impact on their trips. Before this iteration, I had the shuttle programmed as a flow with a periodicity that approximated the travel time
of the loop. It was not exact, which is why I wanted to use rerouters to keep one vehicle in a loop so it could be affected by traffic. In the previous iteration, there was a noticeable impact on pedestrian routing, where many pedestrians used the shuttle
route(s) I programmed. Now, with the looping route, none of the pedestrians behave differently. I am not getting any warning or error messages so I am not sure what to do. Would someone be willing to look over one instance of my code? I am aiming for three shuttle loops, but if I can just get one working I can fix the rest. Any feedback or ideas is greatly appreciated. I can send my code out on this thread at a later point as well. Thank you, Matty |