You can still build the SDM from source and install the executable in a known location. On the launch configuration debugger tab, uncheck the “Use built-in SDM…” option, then specify the path to the location of your custom sdm.
The SDM source is available from the update site:
Regards, Greg
Hi folks, I would like to know how could I proceed to deal SDM when
testing a new architecture. Looking at the documentation, I found
out this statement:
The SDM executable must be installed in a location that is
accessible to the launch mechanism employed by the frontend. This
may mean copying the executable to nodes of a cluster, for
example. Since this is highly dependent on the target
architecture, PTP does not provide any additional
installation assistance.
I believe that there are changes that need to be done in order to
get it working, but I don't know what they are and from where to
start. In the past I use to download the source code and build it,
but it has changed and it is no longer needed. That said, what
should be the best approach to get it working ?
Thank you !
_______________________________________________ ptp-user mailing list ptp-user@xxxxxxxxxxx https://dev.eclipse.org/mailman/listinfo/ptp-user
|