Hi,
my synchronized setup looks like this -
local: Linux Ubuntu 64-bit + OpenMPI + GNU compiler
remote: RedHat Linux 64-bit + IBM PE + Intel compiler
I try to use SDM on the remote side, setting a break point and proceed all MPI ranks to this break point. The execution suspends, but the the source code view shows
* one tab with the correct source code hello_par.c
marking the line 11 with the break point in green
* one tab with header
"1 main() hello_par.c:11 400803"
and window contents "source not found"
Does that mean that executables compiled with Intel are not supported ? Or is SDM only confused about the location of the sources. But then I didn't find the place to tell SDM where to look for the sources.
And, BTW, is there a source view the assembly code and a way to step through the code Op-code by Op-code ?
--
Mit freundlichen Grüßen / Kind regards
Dr. Christoph Pospiech
High Performance & Parallel Computing
Phone: +49-351 86269826
Mobile: +49-171-765 5871
E-Mail: christoph.pospiech@xxxxxxxxxx
-------------------------------------------------------------------------------------------------------------------------------------------
IBM Deutschland GmbH / Vorsitzender des Aufsichtsrats: Martin Jetter
Geschäftsführung: Martina Koederitz (Vorsitzende), Reinhard Reschke, Dieter Scholz, Gregor Pillen, Christian Noll, Ivo Koerner
Sitz der Gesellschaft: Ehningen / Registergericht: Amtsgericht Stuttgart, HRB 14562 / WEEE-Reg.-Nr. DE 99369940
|