I've got an issue with starting up the debugger (using Kepler,
Linux, x86) that doesn't seem to correspond to anyone else's
problem. I'm working on a system where the cluster and the
workstation share a file system, so I do all my editing locally,
then run using a remote session. It runs fine (though it won't
output to the console until I kill the job for some reason).
Now wen I set up the debugger, I use the same parallel settings.
I've got the SDM executable sitting in one of my PATH directories.
However, when I try to execute a debug session, it dies immediately,
and I get this:
363a2069-bf31-46f5-88d9-40f907256d3c: FAILED
#PTP job_id=21990
--------------------------------------------------------------------------
mpirun noticed that process rank 0 with PID 21994 on node quad40
exited on signal 8 (Floating point exception).
--------------------------------------------------------------------------
Not sure why I'd be getting a floating point exception. Anyone run
into a similar issue and can help?
--
Joshua
Strodtbeck, PhD | Research Engineer
O: (608)
831-3811
|