[
Date Prev][
Date Next][
Thread Prev][
Thread Next][
Date Index][
Thread Index]
[
List Home]
Re: [ptp-user] Where is the sdm executable ... on AIX ?
|
On Wednesday, November 28, 2012 20:46:42 Dr. Christoph Pospiech wrote:
> * remote project (AIX 6.1 on POWER6 with xl compiler suite) - I took the
> very same zip file (well, I had to repack it as tar.bz2 file), but
> compilation failed for each proxy. There was a gcc installed but configure
> claimed that this didn't work. When I spotted the message 'unknown option
> -qversion' in the config.log, I switched to xlc, as this compiler knows
> -qversion. But xlc sprouted lots of error messages and no binary was
> generated
> (-> so far not a success story)
>
> Any advise ? Is there a special trick for AIX ?
I should have been more specific. Most of the messages the xlc spluttered out
were informational messages. The one that finished the compilation of sdm off
was the following.
xlc_r -I. -g -g -qinfo=gen -qcpluscmt -g -o testaif \
testaif-testaif.o libaif.a
ld: 0711-317 ERROR: Undefined symbol: .asprintf
ld: 0711-345 Use the -bloadmap or -bnoquiet option to obtain more information.
make[1]: *** [testaif] Error 8
make[1]: Leaving directory
`/pf/k/k205001/remote_tools/proxy/org.eclipse.ptp.debug.sdm_6.0.3.201211112147/libaif'
make: *** [install-recursive] Error 1
Does this ring a bell with anyone ?
--
Mit freundlichen Grüßen / Kind regards
Dr. Christoph Pospiech
High Performance & Parallel Computing
Phone: +49-351 86269826
Mobile: +49-171-765 5871
E-Mail: christoph.pospiech@xxxxxxxxxx
-------------------------------------------------------------------------------------------------------------------------------------------
IBM Deutschland GmbH / Vorsitzender des Aufsichtsrats: Martin Jetter
Geschäftsführung: Martina Koederitz (Vorsitzende), Reinhard Reschke, Dieter
Scholz, Gregor Pillen, Joachim Heel, Christian Noll
Sitz der Gesellschaft: Ehningen / Registergericht: Amtsgericht Stuttgart, HRB
14562 / WEEE-Reg.-Nr. DE 99369940