[
Date Prev][
Date Next][
Thread Prev][
Thread Next][
Date Index][
Thread Index]
[
List Home]
[ptp-user] (PTP Run Configuration == Parallel Application) + Resource manager MPICH2
|
Hi,
I know that I am presumably in an unsupported state, but I needed a certain
configuration - so I tried to do a remote launch of a parallel application
using the Resource manager MPICH2, knowing that it is actually not MPICH2 but
Intel MPI v 4.xx .
In simple cases this works OK (Intel MPI and MPICH2 are close enough), but
today my hack failed me. It complained that I would use a non-existent option
-x for mpiexec. I never specified this option, so where did it come from ?
It seems that either the run configuration or the resource manager are adding
additional options here. How can I find out ?
Just to mention - if I login on the remote host and type the mpiexec command
into the command line prompt, that eclipse is supposed to issue, the job runs
fine.
--
Mit freundlichen Grüßen / Kind regards
Dr. Christoph Pospiech
High Performance & Parallel Computing
Phone: +49-351 86269826
Mobile: +49-171-765 5871
E-Mail: christoph.pospiech@xxxxxxxxxx
-------------------------------------------------------------------------------------------------------------------------------------------
IBM Deutschland GmbH / Vorsitzender des Aufsichtsrats: Martin Jetter
Geschäftsführung: Martina Koederitz (Vorsitzende), Reinhard Reschke, Dieter
Scholz, Gregor Pillen, Joachim Heel, Christian Noll
Sitz der Gesellschaft: Ehningen / Registergericht: Amtsgericht Stuttgart, HRB
14562 / WEEE-Reg.-Nr. DE 99369940