Hi
Ilya ,
Thanks for your fast reply!!
Packages are installed…!
Wlan Setup:
auto wlan0
allow-hotplug wlan0
iface wlan0 inet dhcp
wpa-ssid "pulse"
wpa-psk "password"
pi@maximo_mmitogateway ~ $ lsusb
Bus 001 Device 006: ID 7392:7811 Edimax Technology Co., Ltd EW-7811Un 802.11n Wireless Adapter [Realtek RTL8188CUS]
Bus 001 Device 005: ID 046d:c016 Logitech, Inc. Optical Wheel Mouse
Bus 001 Device 004: ID 046d:c312 Logitech, Inc. DeLuxe 250 Keyboard
Bus 001 Device 003: ID 0424:ec00 Standard Microsystems Corp. SMSC9512/9514 Fast Ethernet Adapter
Bus 001 Device 002: ID 0424:9514 Standard Microsystems Corp.
Bus 001 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub
pi@maximo_mmitogateway ~ $ ifconfig wlan0
wlan0 Link encap:Ethernet Hardware Adresse 74:da:38:5e:03:18
inet6-Adresse: fe80::d118:522c:1e45:b30c/64 Gültigkeitsbereich:Verbindung
UP BROADCAST MULTICAST MTU:1500 Metrik:1
RX packets:0 errors:0 dropped:893 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
Kollisionen:0 Sendewarteschlangenlänge:1000
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
pi@maximo_mmitogateway ~ $ iw dev wlan0 info
command failed: No such device (-19)
pi@maximo_mmitogateway ~ $ iwconfig wlan0
wlan0 unassociated Nickname:"<WIFI@REALTEK>"
Mode:Managed Frequency=2.412 GHz Access Point: Not-Associated
Sensitivity:0/0
Retry:off RTS thr:off Fragment thr:off
Power Management:off
Link Quality:0 Signal level:0 Noise level:0
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
Mit freundlichen Grüßen / Best regards
Christian Voller-Niederl
Maintenance System Manager
Maintenance System
Mayr-Melnhof Karton Gesellschaft m.b.H.
Wannersdorf 80, 8130 Frohnleiten, Austria
Tel: +43 3126 2511 538
Fax: +43 3126 2511 101
E-Mail:
christian.voller-niederl@xxxxxxxxxxxxx
Homepage: www.mm-karton.com
------------------------------------------------------------------------------
Mayr-Melnhof Karton Gesellschaft m.b.H.
Sitz der Gesellschaft: Frohnleiten
Handelsregister Graz: FN 62874m
UID-Nr: ATU 37002202
Geschäftsführer: Dr. Wilhelm Hörmanseder, Mag. Gernot Schleiss
Diese E-Mail enthält keine verbindlichen Erklärungen. Ausschließlich Erklärungen der vertretungsbefugten Personen der Gesellschaft
sind verbindlich und wirksam.
This e-mail does not include any binding declarations. Only declarations by authorized representatives of the company shall be deemed
legally enforceable and binding.
Von: kura-dev-bounces@xxxxxxxxxxx [mailto:kura-dev-bounces@xxxxxxxxxxx]
Im Auftrag von Binshtok, Ilya
Gesendet: Donnerstag, 17. Dezember 2015 23:54
An: kura-dev-request@xxxxxxxxxxx; kura-dev@xxxxxxxxxxx
Betreff: Re: [kura-dev] Kura on Raspbian 2 with WLAN and HTTPS
Hi Christian,
I tried Edimax USB dongle on my Raspberry Pi 2 and it works. Here is what I am getting:
1. Use lsusb to see if Wifi stick is detected as USB device:
root@eurotech-pi:/home/pi# lsusb
Bus 001 Device 006: ID 7392:7318 Edimax Technology Co., Ltd
Bus 001 Device 005: ID 045e:00cb Microsoft Corp. Basic Optical Mouse v2.0
Bus 001 Device 004: ID 413c:2003 Dell Computer Corp. Keyboard
Bus 001 Device 003: ID 0424:ec00 Standard Microsystems Corp. SMSC9512/9514 Fast Ethernet Adapter
Bus 001 Device 002: ID 0424:9514 Standard Microsystems Corp.
Bus 001 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub
2. Check if wlan0 interface is there:
root@eurotech-pi:/home/pi# ifconfig wlan0
wlan0 Link encap:Ethernet HWaddr 00:1f:1f:55:62:12
inet addr:172.16.1.1 Bcast:172.16.1.255 Mask:255.255.255.0
inet6 addr: fe80::21f:1fff:fe55:6212/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:38 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:8260 (8.0 KiB)
3. Check WiFi mode. Note that Kura switched wifi to the Access Point mode by default.
root@eurotech-pi:/home/pi# iw dev wlan0 info
Interface wlan0
ifindex 3
wdev 0x1
addr 00:1f:1f:55:62:12
ssid kura_gateway_B8:27:EB:64:95:23
type AP
wiphy 0
channel 1 (2412 MHz), width: 20 MHz (no HT), center1: 2412 MHz
or
root@eurotech-pi:/home/pi# iwconfig wlan0
wlan0 IEEE 802.11bg Mode:Master Tx-Power=20 dBm
Retry short limit:7 RTS thr:off Fragment thr:off
Power Management:on
Please let me know what responses to above commands are you getting ...
Also, note that for Kura to run properly, the following packages must be installed:
sudo apt-get install telnet
sudo apt-get install dos2unix
sudo apt-get install ethtool
sudo apt-get install iw
sudo apt-get install bind9
sudo apt-get install hostapd
sudo apt-get install openvpn
sudo apt-get install isc-dhcp-server
Best regards,
Ilya
USA – 12721 Metcalf Ave STE 102 | Overland Park Kansas 66085 | Tel. +1 913.549.1000 | Fax +1 913.549.1001 |
www.eurotech.com
Hi,
I want to use Kura in a big IoT Project in our Mill (Condition Monitoring).
Therefore we are planning to use Raspbian 2 with Kura as a Gateway.
On big point is to read sensors from places difficult to access so we need WLAN!!!
Using USB WLAN Sticks Edimax does not work…!!!
Can I also configure Kura WebUI only for HTTPS? How is this possible?
Thanks a lot.
Mit freundlichen Grüßen / Best regards
Christian Voller-Niederl
Maintenance System Manager
Maintenance System
Mayr-Melnhof Karton Gesellschaft m.b.H.
Wannersdorf 80, 8130 Frohnleiten, Austria
Tel: +43 3126 2511 538
Fax: +43 3126 2511 101
E-Mail:
christian.voller-niederl@xxxxxxxxxxxxx
Homepage: www.mm-karton.com
------------------------------------------------------------------------------
Mayr-Melnhof Karton Gesellschaft m.b.H.
Sitz der Gesellschaft: Frohnleiten
Handelsregister Graz: FN 62874m
UID-Nr: ATU 37002202
Geschäftsführer: Dr. Wilhelm Hörmanseder, Mag. Gernot Schleiss
Diese E-Mail enthält keine verbindlichen Erklärungen. Ausschließlich Erklärungen der vertretungsbefugten Personen der Gesellschaft sind verbindlich
und wirksam.
This e-mail does not include any binding declarations. Only declarations by authorized representatives of the company shall be deemed legally enforceable
and binding.
Classified as
MM Internal / MM Project