| [gendoc-dev] Vote for Committer status for Antonio Campesino was started by Anne HAUGOMMARD |
modeling.gendoc Committers, This automatically generated message signals that Anne HAUGOMMARD has nominated Antonio Campesino as a Committer on the modeling.gendoc project. The reason given is as follows: Antonio has been involved in the Gendoc community for one year. Antonio has participated to the identification or fix of the following bugs : https://bugs.eclipse.org/bugs/show_bug.cgi?id=496908 https://bugs.eclipse.org/bugs/show_bug.cgi?id=496848 https://bugs.eclipse.org/bugs/show_bug.cgi?id=492954 https://bugs.eclipse.org/bugs/show_bug.cgi?id=486793 https://bugs.eclipse.org/bugs/show_bug.cgi?id=486703 https://bugs.eclipse.org/bugs/show_bug.cgi?id=484127 https://bugs.eclipse.org/bugs/show_bug.cgi?id=455640 Antonio has contributed to Gendoc : https://git.eclipse.org/r/#/q/project:gendoc/org.eclipse.gendoc+owner:%22an tonio.campesino.robles%2540ericsson.com%22 The vote is being held via the MyFoundation portal: voters *must* use the portal for the votes to be properly recorded. The voting will continue until either all 3 existing Committers have voted or until they have been given enough time to vote, even if they do not do so (defined as at least one week). Because there are three or fewer existing Committers, they must all vote and vote +1 for a successful election. Eligible Committers must cast their votes through their My Foundation portal page (do NOT just reply to this email; your vote will not be correctly recorded unless you use the portal): http://portal.eclipse.org/ The project Committers eligible to vote are: Aicha Boudjelal Tristan FAURE Anne HAUGOMMARD *NOTE*: Successful elections are left open for a maximum of 120 days to allow for processing of paperwork. After that time the election will be expired, regardless of its current status. Should papework processing on the part of the candidate take more time than allowed, a new election will have to be held. If you have any questions, please do not hesitate to contact your project lead, PMC member, or the EMO <emo@xxxxxxxxxxx>