Overlapping Connections [message #760671] |
Sun, 04 December 2011 04:46 |
Maqsood Ahmed Messages: 41 Registered: September 2010 |
Member |
|
|
Hello all,
In my diagram there are a lot of connections, some of them start and end at same anchors(Fixed Point), also they have the same bend points locations.
Problem: Is there any way in which the user can know that there are overlapped connections? On mouse hover i couldn't find any solution because these connections are
drawn one after another , in the end after drawing some 100+ connections i will not know which are the ones overlapping in the diagram.
The user expects some expand icon on the overlapped connections , if any, and then when he clicks that icon, all the overlapped connections are separated out.
As a alternative i have provided properties tab details, where on selection of any connection, all the overlapped connections are populated in a table.
Any ideas / suggestions?
Thanks
Mak
|
|
|
|
|
|
Powered by
FUDForum. Page generated in 0.04641 seconds