Question on Object Mapping [message #1100341] |
Tue, 03 September 2013 02:10 |
Mobile Tester Messages: 5 Registered: August 2013 |
Junior Member |
|
|
Hey All!
I just started experimenting automating an Eclipse RCP application with Jubula and its been fun! With the help of the test recorder I'm able to navigate through my test cases, but I'm stuck at the stage where I need to validate if my test output is correct.
I have difficulty with one of the tree structures which has a list of check boxes inside a control but Ctrl + Shift + Q gets the entire tree. How do I make a more specific selection?
Apologies if this is too trivial, but I havnt been able to figure out!
Appreciate your time!!
Edit: I was able to navigate through the output of the table!
[Updated on: Tue, 03 September 2013 21:47] Report message to a moderator
|
|
|
|
|
|
Powered by
FUDForum. Page generated in 0.03576 seconds